[speedygonzales]

Originally Posted by Tom

So friggin simple its blowing my mind.

Originally Posted by Tom

http://www.fullsizechevy.com/forum/g...i-install.html

Are you kidding me? Have you read the instructions for the rear discs?

Let me grab a few little tid bits.

but there is a little alignment pin on the plates that needed to be cut off

The other 3 issues were that the backing plates needed to be spaced out about a 1/2"

elongate the bolt holes on the axle a little

the outside of the axle flange needed to be ground down some so that the backing would slide over it

And the guy that wrote this article no longer has ABS.

Originally Posted by 400sbctruck

Curious about the NBS 13" vs slotted replacement(I can drill
And/or slot at work).

I do not care for drilled since they tend to crack. I like slotted or dimpled where the cuts don't go all the way through.

http://www.summitracing.com/parts/ebc-usr7013/overview/