Re: 350 TH pump lip seals - internal
Ok, I got the last snap ring out and am down to just the low/reverse apply piston which Cliff Ruggles says to just lift out. Hmmmm, with 3 o-rings on it it does not just want to just lift out. I have found little to grab hold of to get it out.
I am still pondering.
Also...... I did not find what Cliff Ruggles calls a RETAINER SPRING supposedly near the center support assembly. I did not hear anything hit the floor. But will look some more. I do not think it was in it. It looks like 1/8" wire of sorts.
I did find the Retainer slug. It looks similar but different than the manual.
OK, missed a step on the low/reverse apply drum removal- it takes air pressure - case is now empty.
__________________
1942 Chevy 1/2 ton Rod, 1959 GMC 1/2 ton Fleet Stepside, 1967 Chevy SWB K10, 1985 Corvette Coupe 4+3, 2015 Chevy Duramax reg cab 4WD W/T
Last edited by dennislbrooks; 08-28-2020 at 05:41 PM.
Reason: words
|