[cortcomp]

Been working on painting the last of the interior components, and finished filling and sanding the screw holes someone had in the back of the cab. Decided to pull the roof skin after reading about it here, and pack it full of the insulation i got rolls of (cheaper dynamat style stuff) There is some surface rust, and the start of something worse at the gutter/front windshield panel seams, so i'll clean that up, clean up the inside of the roof panels, port 15 them, insulate, change the dome light fixture, and insulate the C panels behind the inner panel that i couldn't get to before. Put the top back on, weld it, fill it, and prep the white part of the cab for paint. With all the rubber out, it's just to good an opportunity to clean it all, replace all the cracking seam sealer, fill some holes properly by welding and filling, and then paint, then put new rubber back in.