Quote:
Originally Posted by 50seven
I just lowered a truck axle over and the driveshaft needed to be shortened by 3/4"?
|
truck has 1.7x 60' so it does get up and go pretty decent, I installed a flip kit in my 2004 silverado and the kit is designed to move the axle back 1" to keep it alined where it suppose to be every one i talked to tell me the lower you go the more it move the rear end forward but in this case for some reason its .75" back? pinion angle was checked and its fine
trying to figure this out I don't want to blew another tail case or possibly trans