|
Re: Clifford the Big Red Truck~~The Build
So as it sits now,
I have to snug up the exhaust (after I clearance it)
Drill a couple new holes in the frame for the crossmember
Finish running the brake lines on the frame
Figure out a scatter shield/blanket for the bell housing
Set up the rear fuel tank and plumb the lines/filter to the intake
Plumb the trans cooler lines to the front of the truck
Run battery cables from the rear to a front power distribution block
Get the driveshaft finished
Then ill take a break and start working on the truck side of it for the clutch pedal assembly, take measurements to see how much I will have to raise the trans tunnel.
And I'm sure more stuff.... Also if any of you guys have questions or need measurements, holler at me.
Bubba
|