Re: HD Carrier Bearing Mount
Captain
Do you still make/have any of these brackets?
I may need one. Not sure yet if its going to work with my crossmember though.
My 3/4 - 1/2 ton conversion is fighting me at every turn. I thought I did all the research before I bought the new drop xmember and coil spring set up, but I did not at that time know about the different carrier bearings and drive shaft combos.
Basically if I could find the 1/2 ton HD carrier bearing with the 1.378" ID bearing that would be great and would work perfectly with the parts I already have. But I have found nothing like that.
My thought is that I could use your bracket but bent the tabs back down to flat, then drill holes in my xmember. My xmember is flat on the bottom side, unlike the stock one.
|