[scott123]

I can measure hub to hub on what I have but I don't know where the axles land in regard to being where the 2WD hub would have landed.

The frame is a 2WD. I bought it on the way to the scrap yard. The previous owner was attempting to make it a 4WD. He added leaf springs on both ends. No welding or cutting, just bolt on. The project turned out to be more then had had originally planned.

2 rear ends, a 350/205 set up bolted to a 2WD frame.

The hub to hub measurement will be accurate for what is sitting here but not sure if either axle landed center/or where it should have landed.

It was a knee-jerk reaction to seeing all that being scrapped so I bought it.

Measurements and pics later today when I get out there.

Scott