Here's one of the three 5/64" hex bolts that attached the billet grille to the grille shell. This is the only one from the top that was successfully removed without complete butchering.
This is the hole in which the above bolt was removed from:
Below is a pic of the billet grille. You can see the long bars/rods which allow for attaching to the grille shell. The ends of these are threaded both top & bottom. Three of those 5/64" bolts were used to attach the billet to the top of the grille shell.
This is a pic of one unused threaded bar which was originally located towards the bottom of the grille shell. The upper end of this bar had to be hacked off, which resulted in me losing the threaded portion. Since the bolt is still stuck in the piece I cut off, I will now have to cut a matching portion from the bottom end of this bar & reattach to the top. This is the only way I can continue to utilize the mounting of the billet via the top of the grille shell.
And this is the end I hacked off. As you can see, it's not threaded this far down.
