The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

FAKKY · 05-26-2019, 07:06 PM

Thanks Miraclepie.
Yes - I was planning on probably putting heat wrap on the headers anywhere where there is close to contact with the ujoint if I have to.
I think part of problem is I need to try a straighter run ..... and lose a joint.

Just rally struggling with the double joints as the sort of flex in the middle (as they can) if everything is not 100% lined up and supported. So almost impossible to mock up. Literally been at this for 4-5 hours each day yesterday and today. Ready to push it off the edge of the pier.

05-26-2019, 07:06 PM	#288
FAKKY Registered User Join Date: Sep 2016 Location: Redington Beach Posts: 1,312	Re: 57 Panel "FAKMLC" build Thanks Miraclepie. Yes - I was planning on probably putting heat wrap on the headers anywhere where there is close to contact with the ujoint if I have to. I think part of problem is I need to try a straighter run ..... and lose a joint. Just rally struggling with the double joints as the sort of flex in the middle (as they can) if everything is not 100% lined up and supported. So almost impossible to mock up. Literally been at this for 4-5 hours each day yesterday and today. Ready to push it off the edge of the pier. __________________ FAKKY 57 PANEL BUILD