The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**cdub2010** · 02-27-2018, 02:05 AM

I looked at Schoenfeld and brp hot rod stuff, but since I'm cheap i went with speed engineering vband ls swap headers. They fit pretty good on my 77 k25 chassis. They cleared the frame rails, a little close to the block on the pass. side, and I had to trim the "ears" off the 4l80e housing.

It looks like I can run my 2.5" exhaust pipe tucked up high next to the frame rails. Im using a column shift out of my 87 Jimmy, along with a lengthen shifter rod. It works pretty good and still clears the exhaust pipe, its tough to get first but it just might need some adjusting.

02-27-2018, 02:05 AM	#2
cdub2010 Senior Member Join Date: Apr 2014 Location: detroit mi Posts: 206	Re: LS swap Headers in 4x4? I looked at Schoenfeld and brp hot rod stuff, but since I'm cheap i went with speed engineering vband ls swap headers. They fit pretty good on my 77 k25 chassis. They cleared the frame rails, a little close to the block on the pass. side, and I had to trim the "ears" off the 4l80e housing. It looks like I can run my 2.5" exhaust pipe tucked up high next to the frame rails. Im using a column shift out of my 87 Jimmy, along with a lengthen shifter rod. It works pretty good and still clears the exhaust pipe, its tough to get first but it just might need some adjusting.