[harrisoncole4]

As i mentioned earlier, the blazer floor was not yet available at this point so we had to cut down a truck floor. The existing floor on my blazer prior to disassembly was so rusty that i couldn't even tell exactly how the body line on the floor met up with the step up plate. While the result isn't 100% factory correct, it was still really well done. Once the weld was ground flat, i almost now prefer it over the factory flare up that is there.

The rockerbox area of the blazer is obviously fairly complicated. With all reproduction pieces, i was worried that everything wouldn't go together. it needed a slight modification so that the one end would sit on the cross brace properly. Other than that, the support brackets and the rest of the pieces all went in really smoothly.