Hey guys, it's been a couple weeks and i got little done...
got the floor shifter mounted. the linking rod is a little short, so i'm awaiting on a part to complete this little project...
yesterday i pulled out the old airline and valves to start running fresh line and install my accuair vu4 and dakota digital controller.
out with the old....
in with the new....
I'm still playing around with layout of the tanks. the PO had a space for the compressor under the truck, so i'm moving them there until i get my engine mount (which won't happen until i get my new motor
) on the tanks, I'm thinking under the truck where the gas tank was...2x 3gal tanks. i do have room on the outside of the frame on the pass. side, but i'm not sure it's a good idea...
old setup...
today after clearing things up...
