[landarts]

Here is a picture of the inner/rocker outer floor all welded in with the rocker panel just clamped on to see what type of modifications will need to be made to fit properly. Also one of the front section of the rocker to see where it does not really quite form around the B-Pillar. I will make a few cuts in the areas that it is formed and that will allow it to be reformed to B-pillar then tack it up. Once that is wrapped I will remount the door and adjust for gaps and alignment. When good I will then tack in rocker and remove door again. Weld it up and finish for primer and paint.