The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

OrrieG · 07-16-2007, 12:48 AM

Mike - Ford's run a similar set up, but since the conversion drops the transfercase and trans down 4" in relationship to the frame I needed to fab the mount. Also the 205 mount boss is in the center of the case, the 203 is on the bottom. I chose to use the angle so the rubber etc is tucked up in the frame rail a little higher and to give me some wiggle room in the fabrication.

07-16-2007, 12:48 AM	#38
OrrieG Registered User Join Date: Jun 2006 Location: Idaho Posts: 8,800	Re: Lurker OrrieG Progress Pics Mike - Ford's run a similar set up, but since the conversion drops the transfercase and trans down 4" in relationship to the frame I needed to fab the mount. Also the 205 mount boss is in the center of the case, the 203 is on the bottom. I chose to use the angle so the rubber etc is tucked up in the frame rail a little higher and to give me some wiggle room in the fabrication.