The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Flatpat · 07-01-2017, 06:55 PM

Finally got some work done on the truck. Got my column shifting of the 47rh worked out with an Ididit cable kit. Got the wiring ran for the Compushift Mini trans controller. Ended up switching out the dodge np205 1410 rear yoke for a 1350 off one of my GM 205s. The intermediate driveshaft from the '78 had a 1310 yoke. Went searching through my parts trucks and the intermediate shaft from my '90 R3500 had a 1350 yoke. Got it cut down to proper length. Going to pick up new ujoints tomorrow to get it installed and then work on fitting the rear driveshaft. Slowly by surely.

07-01-2017, 06:55 PM	#10
Flatpat Registered User Join Date: Feb 2013 Location: Elgin, TX Posts: 114	Re: Flat Pat's '78 Crew Cab Finally got some work done on the truck. Got my column shifting of the 47rh worked out with an Ididit cable kit. Got the wiring ran for the Compushift Mini trans controller. Ended up switching out the dodge np205 1410 rear yoke for a 1350 off one of my GM 205s. The intermediate driveshaft from the '78 had a 1310 yoke. Went searching through my parts trucks and the intermediate shaft from my '90 R3500 had a 1350 yoke. Got it cut down to proper length. Going to pick up new ujoints tomorrow to get it installed and then work on fitting the rear driveshaft. Slowly by surely. __________________ I may have a problem.. 1976 K20 Crew, 1978 K30 Crew, 1981 K30 Crew, 1985 C30 Crew, 1987 C30 Dually Crew, 1988 R3500 Crew, 1990 R2500 Crew, 1991 V3500 Crew, 1991 V3500 Dually Crew.