|
Re: Project "Bickle" 1948 1/2 ton 4.3 4l60e
I have enjoyed reading and learning from your projects that deal with S10 and AD Chevy frame swaps. I too am working on a frame swap, but not a Chevy. My project is a 1950 4X4 Willys truck going on a 2000 extended. The bad part of this story is that the S10 engine and transmission are very tired. Slipping tranny and engine guzzling oil.
I have a 1994 4X4 K1500 whose body is nearly rusted off. The engine and the transmission were replaced 8 years ago. The engine and transmission now have less than 40,000 miles. My question for you is. Will the engine mounts from the 2000 4.3 work on the 1994 4.3? I assume they will, but there are times when knowledge is better than assumptions. The 1994 is used very little so I am hoping that this is a doable swap. I plan on using the 1994 electronics
Keep up the good work, I look forward to each new page you post.
Stan from Nebraska
|