Quote:
Originally Posted by hatzie
Go to the Borg and get the 1,000 count bag of 4" cable ties. I use them to neaten up and bundle wiring harnesses.
https://www.homedepot.com/p/Commerci...00MB/203531926
I use the Paladin/Greenlee 1828 cable tie gun but you can cinch them up by hand and use a pair of sharp good quality flush cutting electronics dikes to cut the tails off flush with the tabs. Split poly will slide right over the small wire ties.
The Paladin 1828 tool is around $25. It puts the exact same tension on every tie and cuts them off flush in one fell swoop but they're pricey.
A good set of dikes like Hakko CHP-170s are $6. The Xcelite 175-M dikes are $20 but they aren't any better than the Hakko dikes. |
bro you always give Rock Star advice, I just want you to know the detail and explanations you provide are very much appreciated 👊🏼