The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed

88Stanger · 10-05-2020, 09:51 AM

Small update: So the Mini-Split is working great! I am amazed at how well it does work. I plan to monitor the temp in the shop and how much it affects the power bill to get a good understanding how much it cost to keep the shop at a 62 degrees at a min.

As for the truck, I am finally back to work on it. Just about got the bottom of the cab by in the door area done. I would have it done but we ran out of gas, damnit. So this week we will have this door area done and this weekend i plan to have the other area below the passenger door done and start on the header area inside and out.

10-05-2020, 09:51 AM	#308
88Stanger Registered User Join Date: Mar 2015 Location: Washington State Posts: 1,644	Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed Small update: So the Mini-Split is working great! I am amazed at how well it does work. I plan to monitor the temp in the shop and how much it affects the power bill to get a good understanding how much it cost to keep the shop at a 62 degrees at a min. As for the truck, I am finally back to work on it. Just about got the bottom of the cab by in the door area done. I would have it done but we ran out of gas, damnit. So this week we will have this door area done and this weekend i plan to have the other area below the passenger door done and start on the header area inside and out.