The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1971Stepside** · 07-27-2019, 04:41 PM

[QUOTE][How far is your engine from the draglink and crossmember, and how many degrees down is the engine transmission? /QUOTE]

Pic may be sideways because I’m using my phone. Here is a shot of the drag link. I’m using the CTSV pan. Not 100% on my angle but mocked up drive shaft and all is well. I appreciate the positive feedback. Baby steps. Let me know if I can help in any way. We look to be at about the same point in the process

07-27-2019, 04:41 PM	#174
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,930	Re: 1971 Stepside LS Build [QUOTE][How far is your engine from the draglink and crossmember, and how many degrees down is the engine transmission? /QUOTE] Pic may be sideways because I’m using my phone. Here is a shot of the drag link. I’m using the CTSV pan. Not 100% on my angle but mocked up drive shaft and all is well. I appreciate the positive feedback. Baby steps. Let me know if I can help in any way. We look to be at about the same point in the process Attached Images __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."