Quote:
Originally Posted by Dirt's72
Looking good! I'll send mine out to you when you're done. Can you weld?
|
Thanks! I'm a one man shop.. so It might take a while. I just started welding and here's my first go at it ( don't laugh to hard)
The Passenger side inner fender was rotted pretty bad at the front.. It's literally impossible to find a used replacement in good shape. I bought a driver side and cut the front lip out to replace the front lip on my original one. The caveat is you just cant simply do a straight line cut and swap it because the outer edges and holes are not the same. You have to cut those off, too. Then weld them on the opposite side of replacement piece. You also have to plu he center hole and then drill a new hole about 1/2" to the right in order for it to line up. I don't know if any of this make sense to you, but I can tell you it's very time consuming.