[reaper71]

Thanks for checking out my build!

As far as the upper bars go the angle in or out isnt as crucial as long as they are parrallel to the lowers.
your 22 degrees would be fine.

Your lower bars... id try to really get them inside if possable depending how low its going to be.

If you mount under the frame they could drag.

When you start to set it up get your pinion angle set @3 degree up and tack a piece of 1x1 tube to frame and top of rear end tube to hold it in place. now it will make getting the 4 bar mocked up easier.

hope this helps
Mark