[T/C]

And done.

Only issue i ran in to was with templates and getting things even on both sides of the frame.

I don’t know if it’s normal or not but the area that curves in for clearance on the shock mount is longer on the drivers side then it is on the passenger side. I had to trim some of the plate and move it back a little and this led to me getting really close to where my trans crossmember is (and where be) when i raise it.

Only negative of it is that the driver side is just not perfectly semetric with the passenger side behind the motor (will big the hell out of me) but does not effect anything.

I’m pleased with the outcome. I ran out of time so didn’t get to clean up all of the fresh metal will have to do it tomorrow night.

Step notch next! Then time to figure out what to do about the trailing arms hitting the frame after i can figure out exactly that will be...