Test fitting the radiator and fans. I decided I'm going to order a new radiator because someone boogered up one of the trans cooler line fittings and I suspect the tank will crack before I get the old fitting out. Replacing them with AN fittings and braided lines. I just need to figure out some mounting tabs to bolt the radiator and fans to the core support.
Also changed direction on pulling the engine from the Yukon. The bottom side is so rusty and nasty, I decided to leave the trans in the Yukon when I pull it rather than pulling everything out together, so I had to remove the intake to get to the top bellhousing bolts. I ran out of day light shortly after this and the radiator/core support seems to be rusted in place, so the sawzall will come out and I'll just cut it. Its going to the scrapper after I get everything out anyway.
