[OrangeAnimal]

Ok here a bunch of pics I will try my best to describ what is going on in each picture.

This what the inside of the glove box looks like after I cut the bottom off and added a piece of sheet aluminum to cover the hole.



Bottom of the glove box looking at the left side of it. I basically cut the sheet aluminum out in a rectangle and and folded it over the edges.



The right side of the box. I cut off the box on anything hanging past the hinge point. I used Rivets to hold the sheet aluminum on.



Ok the next group of pics shows the A/C and heat box inside of the cab. You can get a sense of how it fits and where it should be. Note I have not attempted hooking up the lines to it yet. It may and probably will be a PITA.








Ok here is the condensor. I am in the Early stages of mounting it. I still have the cut the brackets and paint them b4 I permanently mount them.