[skyphix]

Ran into a few snags getting the engine and trans bolted together initially - couldn't get the alignment dowel to budge with heat or hammer. After I had ordered a new set of alignments dowels someone mentioned using liquid nitrogen (or an upside down air can) to try to cool them enough to get them to pop out. I'll try that next time. My issue is that one stuck in the 4L60E in the Yukon donor. $15 had a new set of billet ones to my house in two days so only a little hold up.









Yep - finally in its resting place. Still a big list of stuff to do but this was one of the biggest steps.