Re: SkinnyG's '61 Apache
Quote:
Originally Posted by SkinnyG
Ok. By my math, it looks like if you're using 5.5" Trex composite boards, you will need SEVEN boards 5-1/2" wide, and TWO boards 4-5/16" wide.
This should work with the 1/2" gap between boards, and 1/16" gap either side of the skid strips.
Film at 11.
I'll confirm when I'm good and ready to run everything through the table saw.... again.
|
So.... I recall the 1/2" gap between boards is to allow the space for wood expansion w/moisture cycling right? With the Trex, I'm curious if that can be minimized since a composite board shouldn't have such issues?
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|