The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

72swbcamo · 03-26-2022, 10:55 AM

I Have 1972 K10. the exhaust manifolds are center dump that extend straight down, both sides. my truck has single exhaust that terminated on the driver's side just behind the rear fender. my truck is a short bed step side.
The driver's side header pipe drops straight down and bends to the rear along the frame rails. The passenger side drops down bends to the rear then crossed over behind the transmission pan and connects to the drive's side pipe. I have the original pipe. I have not been able to locate the header pipe. I had one made up by a muffler shop but the reproduction was not exact and needs to be modified. I will try to get a picture of the pipe and post it to this site.

03-26-2022, 10:55 AM	#11
72swbcamo Active Member Join Date: Dec 2003 Location: Waterbury, CT Posts: 591	Re: Exhaust I Have 1972 K10. the exhaust manifolds are center dump that extend straight down, both sides. my truck has single exhaust that terminated on the driver's side just behind the rear fender. my truck is a short bed step side. The driver's side header pipe drops straight down and bends to the rear along the frame rails. The passenger side drops down bends to the rear then crossed over behind the transmission pan and connects to the drive's side pipe. I have the original pipe. I have not been able to locate the header pipe. I had one made up by a muffler shop but the reproduction was not exact and needs to be modified. I will try to get a picture of the pipe and post it to this site.