The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Lee72 · 05-23-2021, 05:36 PM

I did a coil spring Dana 60 swap last year for a friend. What did you do for the track bar? I think that the bracket at the frame is different. Stock track bar from the Eaton was a different length and the angle at the bracket on the frame was more than the one for the Eaton. I shortened his and am looking for the correct bracket. When I got the rear end, I got the rear part of the driveshaft and the track bar but didn’t think to get the bracket. Glad to see someone else has done this also. My friend really likes the 3:54 versus the mid 4: ratio that the Eaton had. I think you’ll like it too.

05-23-2021, 05:36 PM	#31
Lee72 Registered User Join Date: Oct 2000 Location: California,Ky USA Posts: 131	Re: Dana 60 3.54 in the '68 Chevy C20 I did a coil spring Dana 60 swap last year for a friend. What did you do for the track bar? I think that the bracket at the frame is different. Stock track bar from the Eaton was a different length and the angle at the bracket on the frame was more than the one for the Eaton. I shortened his and am looking for the correct bracket. When I got the rear end, I got the rear part of the driveshaft and the track bar but didn’t think to get the bracket. Glad to see someone else has done this also. My friend really likes the 3:54 versus the mid 4: ratio that the Eaton had. I think you’ll like it too.