Quote:
Originally Posted by LostMy65
Have you welded the vent cover back on yet?
If so, did you do anything to seal this seam within the red line?
I will need to dig into my 65 cab to do something about this area.
I recently found a leak coming through in this location.
 |
Yes I have. I had to weld a patch right there so I welded up what was left while I was at it. I could tell it had been leaking through
Quote:
Originally Posted by Solo2002
Very nice
Posted via Mobile Device
|
Thanks!
Quote:
Originally Posted by Bomp
Very Nice. Verrrrrrrry Nice! You had mentioned about doing a tad bit of body work left on the passengers side. I take it that you will be putting in seam sealer too.,? and covering it with epoxy to keep all your work safe from rust.??
Low Elco mentioned on my thread #251 (LORD Fusor 800EZ) is what he uses for a seam sealer.
Hope the info on patch part numbers was of some help.
Great job.
Keep it up.
You keep me motivated to keep working on the '66.  |
Yes, I'll be doing seam sealer and epoxy. I've got to get it warmer in may garage before I can spray anything, though, but I'm working on it. Thanks again for the heads up on the patch panels, I'll be ordering from them when I start on the driver's side.