The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - what seats did you put in your 67-72 Chevy truck ?

nuke82 · 12-04-2013, 12:24 AM

@nos81z28, The seat install was a lot easier than I thought, I was a little afraid of it since my fabrication abilities are almost non-existent. The process was pretty simple and went smoothly, I just sat the seats in the truck to see where I wanted them (warning, if you center the 05 seats in the cab the driver seat will be slightly off center to the steering wheel. It's maybe 1/4 to 1/2 inch but would bother me). Then I marked where the bolt holes were, double checked to make sure everything was straight and then drilled the holes. The extent of fabrication was I had to cut a spacer/perch for the front left driver and front right passenger seat rails as they didn't reach the floor, but all the other holes are good to go. I did make sure to use extra large washers on the back bolts so they don't pull through in the case of an accident.

12-04-2013, 12:24 AM	#67
nuke82 Registered User Join Date: Feb 2013 Location: Moore, OK Posts: 53	Re: what seats did you put in your 67-72 Chevy truck ? @nos81z28, The seat install was a lot easier than I thought, I was a little afraid of it since my fabrication abilities are almost non-existent. The process was pretty simple and went smoothly, I just sat the seats in the truck to see where I wanted them (warning, if you center the 05 seats in the cab the driver seat will be slightly off center to the steering wheel. It's maybe 1/4 to 1/2 inch but would bother me). Then I marked where the bolt holes were, double checked to make sure everything was straight and then drilled the holes. The extent of fabrication was I had to cut a spacer/perch for the front left driver and front right passenger seat rails as they didn't reach the floor, but all the other holes are good to go. I did make sure to use extra large washers on the back bolts so they don't pull through in the case of an accident.