[Jimmer]

Now that 'that' process was underway...I needed to figure out where to mount the 2 gauges...I took a square and marked out a box that I thought the gauges would fit into. After cutting the first hole...I needed to move the top one up a bit.

OK...just noticed that I am out of sequence...I cut the holes before I started the glassing...oh well...feeble brain.

I shot a quick coat of black on the area to see what the gauges would look like and then put the pad back on the dash...

The angle rings are not installed yet.

oh yeah...I used a 2 inch hole saw to cut the dash...went thru like butta!