The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Beelzeburb, The Story More Than a Decade in the Making

Beelzeburb · 05-23-2010, 11:03 PM

The valve cover breather actually came with the K&N air filter kit. I went out to look at it, and while it is a K&N part, the number on the top of it didn't seem to match up with any numbers on their website.
The crankcase vent filters are on the K&N website under the Performance Products section and you can find them by size, so hopefully that helps.

To help appease low'n slow

here's a tiny little smidgen more of the story before my next update about the front axle. I promise the front axle bit will be a large post.

If you were paying attention (remember, there may be a pop quiz later) my brake booster was partially coated with POR-15 in the dusty shot of the engine bay. I took some time to remove it, separate the booster from the MC and throw it in the blast cabinet. After some hand sanding of tricky areas, both the booster and master cylinder got two fresh coats of POR-15 BlackCote.

Much better. Mini update over.

05-23-2010, 11:03 PM	#31
Beelzeburb Devil's in the Details Join Date: Sep 2008 Location: Southern Utah Posts: 353	Beelzeburb: Part 13 - The mini-update The valve cover breather actually came with the K&N air filter kit. I went out to look at it, and while it is a K&N part, the number on the top of it didn't seem to match up with any numbers on their website. The crankcase vent filters are on the K&N website under the Performance Products section and you can find them by size, so hopefully that helps. To help appease low'n slow here's a tiny little smidgen more of the story before my next update about the front axle. I promise the front axle bit will be a large post. If you were paying attention (remember, there may be a pop quiz later) my brake booster was partially coated with POR-15 in the dusty shot of the engine bay. I took some time to remove it, separate the booster from the MC and throw it in the blast cabinet. After some hand sanding of tricky areas, both the booster and master cylinder got two fresh coats of POR-15 BlackCote. Much better. Mini update over. __________________ '70 K10 Suburban - TBI 454, 4L80E, NP241C, Dana 60 & 44 - The 10+ Year Project Thread Datsun 240Z, 510 2 door and an old Honda motorcycle Last edited by Beelzeburb; 05-23-2010 at 11:14 PM.