Re: 57 GMC, frame swap, 4wd, 454 big block, 4 speed
Not a lot of progress to report, but another step forward. I cut out the passenger front fender bottom, which someone had lap-welded on. I also cut out and replaced the hacked up lower section of the brace with a new one. I was able to fix and fit the section of the fender that I cut out, and reinstall it back like it should be with butt-welds. I'm close to the point of removing the front clip and doors, finish welding everything on the fenders, and getting it all media blasted and sprayed in primer now. I have the wiring all routed in the cab and ready to connect to switches, etc. and ran out the firewall heading to the directions where it will go. After I pull the doors and front clip for blasting, I'll prep, mask and paint the interior.
|