Re: 1986 Chevy K30 CUCV/M1008 rebuild
Got some work done on exhaust, prying and heating wasn't working, so cutting torch and grinder came out, all tube seperated, #1 and #2 tubes sat fine when set in place, #3 there is many issues...first was the tube was physically 3 inches longer then #1and #2...so some bending and cutting-all tubes same length, and no contact issues now.
I also had to grind some of the exhaust flange to clear the Offenhauser intake... but now it's almost ready for a carburetor. Distributor is in, need some bolts for the valve cover, and PCV/breathers. I have a new fuel pump ready for install...might be able to make some noise soon.
|