View Single Post
Old 12-05-2017, 07:07 PM   #165
slow4dr
Registered User
 
slow4dr's Avatar
 
Join Date: Mar 2011
Location: SoCal
Posts: 151
Re: TCI to start new R&D Project with a C10!

Still plugging away on the center section. Built the main tranny hoop and tied it in with some downbars. It is just tacked in place at this time. I still need to throw the cab back on to confirm placement. It'll make sense why the tubes are on top of the frame once the cab is back on.



I still need to make a couple tabs to close out the round tube on top of the frame.



The rear tube placement must be 21" behind the front one to fit properly. I plan to tie the driveshaft loop, tranny mount and Torque Arm mount all together in that area.

slow4dr is offline   Reply With Quote