[SCOTI]

Lowers next: The lowers can be tweaked using a torch & BFH, a BF-vise, or a press. The press is the quickest & time was a factor for me so it's what I used for this set.

Remove the brackets from their original locations. You'll flip the drivers upside down & over to the pass side; the pass to the drivers. When you do this, there's about a 5/16" lip that will prevent the bracket from sitting flush.

I install the flipped bracket & mark the area the lip will contact w/a Sharpie. The lip beyond this point will need to be flattened by your method of choice.