Quote:
Originally posted by Gee_Emm
Cutting the vents into the dash is way easier then replacing the whole dash board IMO
|
Why is that? I can see that the hole above the radio would be a snap, but the outer holes appear to be a pain in the ace. I assume there is some slop that can go along with the outer holes as the vent housings are like 3/8-1/2" thick on each side, and will cover sloppy cutting. How'd you do it? Get the vents and what not, then have CPNE come with Boz-All and just hack until everything fit? I'm going to add an AC dash for a future AC conversion, and want to make sure I'm not opening a big ol' can of worms removing and adding a new dash. Thanks Gee....
-adam