View Single Post
Old 02-15-2017, 10:04 PM   #130
rideblue00
Senior Member
 
rideblue00's Avatar
 
Join Date: Feb 2010
Location: Lambertville, MI
Posts: 1,852
Re: My tach install thread

So finally have some internal pics of the Bosch version Tach. I put it in my lathe and hit my 90* angle grinder to it as it was spinning....slow. And the ring seperated easily. No heat to speak of from it either. I was wondering if its the same internals of the reproduction tachs being sold in all the parts catalogs. Not sure, but its a pretty simple setup. Its not a direct drop in, but close. I have also picked up 2 older versions of the Sun tach also. These do not need Transmitters. They are heavy duty tachs. Ill try and post some pics of those also.
Attached Images
    
rideblue00 is offline   Reply With Quote