I feel like i haven't really gotten anything accomplished lately. Just a couple of small updates. Drilled the holes for front upper bag plates. Finally removed the rear upper shock cross brace and angled cross brace behind rear end to prepare for my step notch. Def lots of rivets....I'm sure you all feel my pain too, glad that part is done though haha
Flipped the frame back over and put all the suspension back on to setup for mock up. And made some templates to cut out tomorrow for my rear bag brackets.
Decided I had too many parts floating around so I threw the front bags in to check it out....not so thrilled not sitting nearly where I was hoping but that's ok. about to make some good progress in the next couple of weeks!
Next on my list...
install my step notch
Cup my lowers
And pancake my front crossmember
Posted via Mobile Device