Quote:
Originally Posted by NONHOG
Tendancy to overthink things. lol
|
I think that plagues us all
Back to some finish work on the driver's quarter, we do have a few low spots to address.
Where the wheelwell and rearward offers quite spacious accommodation for hammer work within the quarter, the window area forward of the rear wheel does not fall in the same category. So as much as it pains me, one of the Snap On body hammers was given a top chop..
Yeah, this will do the trick...
For a dolly on the outside, the small shot bag is used to promote small, controllable stretches.
After the hammer work, placing the rule at a slight angle across the seam to use as a profile gauge, the area is much better than before.
This should hold this spot until paint. For now, another item checked off the list...
Moving to the other side, got about half of the quarter's weld seam ground flush on the outside, more to come.
