Quote:
Originally Posted by mongocanfly
Nope..universal joints at each end of the DD
U joints are
Spline to 3/4DD on the bottom
1DD to 3/4 round at the top
|
No problems with vibration at all then? Does it matter if you put the 1"DD or the 3/4 DD side of the collapsible shaft on the column side?
I think I am going to go with this set up from rack to column. U-joint Ford V to 3/4DD, 3/4 DD shaft, U-joint 3/4 DD to 3/4 DD, collapsible shaft and support joint near the u-joint, then what ever U-joint I need to mate the 1"DD to what ever column I end up with. I am wondering if I should put a vibration reducing joint in.