[RADustin]

at some point I got tired of waiting for the firewall panel to come in, so I put the cab back on. This allowed me to work on some underhood fabrication.

one of the first things was to get the inner fenders fit around the coilovers. With how cheap repo panels were, I cut a huge hole in the passenger side one, made a template, then correctly recut another passenger piece and the driver side.







then started on intercooling piping. It's all aluminum, with bead formed ends. Lots of bends but they can be installed or removed without touching anything else.



















again, starting at the bottom most layer of stuff under the hood, I then went to the washer fluid tank. Which will be below the passenger battery. Press broke up some aluminum, added a tube and a machined bung/cap.