The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Dugan · 07-31-2012, 02:04 PM

Im redoing a th350 right now aswell and im at the same point. Only issue I discovered was a bit of air coming out where the snap ring was placed when applying 30 psi.

The direct piston also would not stay up once the trigger was released, but the seal was still made on the pump with the nozzle.

Also, did you have to hold your finger on the other direct drum port on the pump? If i dont, at 30 psi the piston wont rise, but if i do the piston will rise.

Any ideas?

(im also dual feeding this trans)

07-31-2012, 02:04 PM	#121
Dugan Registered User Join Date: Jul 2012 Location: South Jersey, NJ Posts: 4	Re: My TH350 rebuild Im redoing a th350 right now aswell and im at the same point. Only issue I discovered was a bit of air coming out where the snap ring was placed when applying 30 psi. The direct piston also would not stay up once the trigger was released, but the seal was still made on the pump with the nozzle. Also, did you have to hold your finger on the other direct drum port on the pump? If i dont, at 30 psi the piston wont rise, but if i do the piston will rise. Any ideas? (im also dual feeding this trans)