Quote:
Originally Posted by 1964C10
Thanks Protrash!! I didn't look to see if the clamping it offsets it but that is a good point. At the moment I only have 6 to do so I dont mind spending a little extra time getting it right. What do you use after you use a tube cutter to debur the inside? I have read on here to use a drill but then it leaves like a sharp edge which I then file but I think that might be causing a little bit of crooked edge(?)
|
to debur the inside, use a small round file or a drill bit (i think 7/32 works good) You can use the drill bit by hand or if you're careful in a drill.