The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**dmjlambert** · 03-26-2018, 08:52 PM

Thanks all, I am finding them and learning the part names. There are zerks missing but there are holes, so I will get a zerk multitool and some zerks and install.

Questions:

I have found no evidence of a zerk or hole for one, and also no large boot for grease at these places. Is that normal, or am I just not finding it?
1. Pitman arm to center link pivot
2. Idler arm to center link pivot
3. Idler arm to idler arm support pivot

Is there a bell crank somewhere on the truck?

In the illustration and chart above where it says "Intermediate Steering Shaft (PA10)" does the PA10 mean some other type of vehicle, not a C10 so I don't need to worry about that one?

03-26-2018, 08:52 PM	#18
dmjlambert Senior Member Join Date: Apr 2016 Location: Cypress, TX Posts: 3,562	Re: Location of all Zerk fittings? Thanks all, I am finding them and learning the part names. There are zerks missing but there are holes, so I will get a zerk multitool and some zerks and install. Questions: I have found no evidence of a zerk or hole for one, and also no large boot for grease at these places. Is that normal, or am I just not finding it? 1. Pitman arm to center link pivot 2. Idler arm to center link pivot 3. Idler arm to idler arm support pivot Is there a bell crank somewhere on the truck? In the illustration and chart above where it says "Intermediate Steering Shaft (PA10)" does the PA10 mean some other type of vehicle, not a C10 so I don't need to worry about that one?