Re: Anyone Done a Gen. 3 Hemi Swap on a C/10?
Glad you all have got good service out of your LS engines. Just had a couple of lemons just really turned me off GM engines post '87. As you can tell, I'm still a little bitter. That being said my mother does currently have an Alloytec that I think is a fantastic little engine just a little too small for a 4000 lb pickup. Then again the little AWD car it's in probably ends up weighing about the same. HMMM, turbo Alloytec C/10? That may have to warrant consideration.
Anyone think a TPI on a 400 sbc would be decent? Not a standard TPI but with some decent aftermarket runners and a lower intake. An aluminum big block would be perfect but the price of the block is a bit more than I care to spend.
Posted via Mobile Device
|