The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

swyfor5 · 01-09-2010, 05:29 PM

Ok, thank's guy's. I get it now! I think I'll go with the DIY 4X4 shackle flip n switch kit, I just like the looks of it better than ORD's shackle flip. Get a pair of ORD zero rates and a set of ORD u-bolt kits. Looking at the yokes on frt end, rear end, t-case, and driveshafts frt & rear. Want to beef all of them up to run the stoutest u-joints possible. Now that I think about this swap, it really isn't that compicated. Just need to aquire the right parts and assemble! Anybody else running the DIY 4x4 shackle flip n switch on a 1 ton axle? Pic's?

01-09-2010, 05:29 PM	#29
swyfor5 Registered User Join Date: May 2007 Location: Marion, Mi. Posts: 2,429	Re: Ready to go 1 Ton/K5 Ok, thank's guy's. I get it now! I think I'll go with the DIY 4X4 shackle flip n switch kit, I just like the looks of it better than ORD's shackle flip. Get a pair of ORD zero rates and a set of ORD u-bolt kits. Looking at the yokes on frt end, rear end, t-case, and driveshafts frt & rear. Want to beef all of them up to run the stoutest u-joints possible. Now that I think about this swap, it really isn't that compicated. Just need to aquire the right parts and assemble! Anybody else running the DIY 4x4 shackle flip n switch on a 1 ton axle? Pic's?