[mrhino]

Got back on installing the front seats. after tring to precisely measure where to cut the floor to drop the hump a few inches. i gave up and just winged it. laid a piece of 1.5 tape around where it looked right with the eyeball and just cut that piece out. then folded it down making the floor flat who- hoo. thew the seat up in there and it is at the perfect ride height. unfortunately now there is a 1" in gap around the hole that i have to fill. next time I think ill only take out about 3/4 of a inch or so.









Now I dont know whether to try and make the piece work or just get a whole new piece of sheet metal and weld that in. I think I would have to mount some kinda bracing underneath new metal to give it some strength. what do you guys think? any sugestions