The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Ghost's68 · 05-03-2018, 04:36 PM

Got the drive side header in yesterday. Did have to modify the trans ear and a small bit of the block to fit the driver side. Over all, it went in a lot smoother then the passenger side.

I purchased a Painless classics wire loom. Looks tons better then plastic stuff you usually see. I’m going to try and tuck it behind the fender so it’s not just hanging in the engine bay. I have to still finishing the hot wire from the battery, just waiting on some packard 56 connectors.

05-03-2018, 04:36 PM	#37
Ghost's68 Registered User Join Date: Jun 2016 Location: American Canyon, CA Posts: 253	Re: And so it begins! Ghost's 68 project Got the drive side header in yesterday. Did have to modify the trans ear and a small bit of the block to fit the driver side. Over all, it went in a lot smoother then the passenger side. I purchased a Painless classics wire loom. Looks tons better then plastic stuff you usually see. I’m going to try and tuck it behind the fender so it’s not just hanging in the engine bay. I have to still finishing the hot wire from the battery, just waiting on some packard 56 connectors.