The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

TA_C10 · 03-20-2019, 12:28 PM

Transmission Crossmember - Customized

Another member showed me this mod and I duplicated his idea. Basically the POL(Performance Online) trans crossmember that I have, the perch is too low for the 4l60e based on my calculations. The angle is too far off(low) so I needed to raise the tailshaft up a couple inches. Instead of using a 2" block or something else in between the perch and the trans mount, I decided to cut off the perch and flip it gaining me approximately 2" lift. I will test it out this weekend and if its good to go clean up the welds and shoot some paint on it. I think its gonna work just fine

03-20-2019, 12:28 PM	#158
TA_C10 Registered User Join Date: Jun 2018 Location: Texas Posts: 1,353	Re: TA_C10: Stage 1 Transmission Crossmember - Customized Another member showed me this mod and I duplicated his idea. Basically the POL(Performance Online) trans crossmember that I have, the perch is too low for the 4l60e based on my calculations. The angle is too far off(low) so I needed to raise the tailshaft up a couple inches. Instead of using a 2" block or something else in between the perch and the trans mount, I decided to cut off the perch and flip it gaining me approximately 2" lift. I will test it out this weekend and if its good to go clean up the welds and shoot some paint on it. I think its gonna work just fine __________________ TA_C10 Stage 1 build - http://67-72chevytrucks.com/vboard/s....php?p=8333444 "It's only money". Last edited by TA_C10; 03-20-2019 at 02:46 PM.